IMPORTANT: Before you disassemble the monitor, be sure that the monitor is turned off and all cables
are disconnected.
IMPORTANT: To position and stabilize the monitor, HP recommends that two people perform these
procedures.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor facedown on a flat surface covered by a protective sheet made of foam or a
clean, dry cloth.
3. Push up the latch (1) near the bottom center of the stand where it attaches to the monitor.
4. Remove the stand (2).
Attaching the monitor head to a mounting device
You might need additional tools such as a screwdriver (purchased separately) when you attach a
mounting device. To avoid damage to your monitor, follow these instructions.
1. Remove the monitor stand.
2. Press down on the cover, and then gently lift it up to remove the plate (1) surrounding the stand
connector. Remove the four screws (2) from the VESA holes located on the rear of the monitor head,
and then remove the monitor stand connector (3).
Attaching the monitor head to a mounting device
9
To Next Page
Loading...
