● Plug the power cord into a grounded (earthed) AC outlet that is easily accessible at all times.
● Disconnect power from the equipment by unplugging the power cord from the AC outlet.
For your safety, do not place anything on power cords or cables. Arrange them so that no one can
accidentally step on or trip over them. Do not pull on a cord or cable. When unplugging the power
cord from the AC outlet, grasp the cord by the plug.
3. Connect a video cable.
NOTE: The monitor automatically determines which inputs have valid video signals. To select any
input, open the OSD menu and select Input.
● Connect one end of an HDMI cable to the HDMI port on the rear of the monitor and the other
end to the HDMI port on the source device.
● Connect one end of a DisplayPort cable to the DisplayPort connector on the rear of the monitor
and the other end to the DisplayPort connector on the source device.
Then, connect one end of a USB Type-C cable to the USB Type-C upstream port on the rear
of the monitor and the other end to the USB Type-C port on the source device. Use only the
HP-approved USB Type-C cable provided with the monitor.
NOTE: The monitor’s USB Type-C port provides data, video, and power delivery (up to 140 W).
The host device must be able to support DisplayPort Alt Mode (video, charging, and USB 3.2)
over the USB Type-C connector.
Connecting the cables
11
To Next Page
Loading...
