2–6 Maintenance and Service Guide
Troubleshooting
Selecting from the Advanced Menu
Table 2-4
Advanced Menu
Select To Do This
Language (or press f2) Change the Computer Setup language.
Boot options
■ Enable/Disable MultiBoot, which sets a startup
sequence that can include most bootable
devices and media in the system.
■ Set the boot order.
Device options
■ Swap the functions of the fn key and
left ctrl key.
■ Enable/Disable multiple pointing devices at
startup. (To set the notebook to support only a
single, usually nonstandard, pointing device at
startup, select Disable.)
■ Enable/Disable USB legacy support for a USB
keyboard, mouse, and hub. When USB legacy
support is enabled
❐ A USB keyboard, mouse, and hub work
even when a Windows operating system
is not loaded.
❐ The notebook starts from a bootable hard
drive, diskette drive diskette, or CD,
CD-RW, or DVD inserted into a drive
connected by a USB connector to the
notebook or to an optional docking
device.
■ Select a parallel port mode: EPP (Enhanced
Parallel Port), standard, bidirectional, or ECP
(Enhanced Capabilities Port).
■ Enable/Disable all settings in the SpeedStep
window. (When Disable is selected, the
notebook runs in Battery Optimized mode.)
To Next Page
Loading...
Need help?
General
