Hard Drive Cables and Connector
Description Spare part number
Hard drive connector cable 665725-001
The hard drive connector is secured with two screws and has two cables that connect to the system
board.
Figure 7-33 Hard drive cable location
To remove the hard drive connector:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer
on page 33).
2. Remove the rear cover (see
Rear Cover on page 34).
3. Remove the hard drive (see
Hard Drive on page 47).
4. Remove the system board cover (see
System Board Cover on page 49).
5. Remove two screws (1) that secure the hard drive connector to the computer.
64 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
To Next Page
Loading...
