Rear webcam and ash
Description Spare part number
Rear webcam and ash 918907-001
IMPORTANT: Make special note of each screw size and location during removal and replacement.
Before removing the rear webcam, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Keyboard (select products only) (see Keyboard (select products only) on page 31)
b. Micro SIM card tray (see Micro SIM card tray on page 32)
c. MicroSD card tray (see MicroSD memory card tray on page 33)
d. Rear cover (see Rear cover on page 34)
e. Disconnect the battery (see Disconnecting the battery on page 35)
Remove the rear webcam:
CAUTION: Use care to prevent damaging the zero-insertion force (ZIF) connector and ribbon cable.
1. Remove the conductive tape (1) from the rear webcam.
Component replacement procedures 43
To Next Page
Loading...
