2. Spread the two retention clips (1) outward until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT: To prevent damage to the memory module, hold the memory module by the edges
only. Do not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
1. Align the notched edge of the module with the tab in the slot (1), and then press the module into the
slot at an angle until it is seated (2).
2. Press down on both sides of the module until the side retention clips snap into place (3).
IMPORTANT: Be sure to press down on both sides of the module using two fingers during
installation. Failure to press on both sides might result in incorrect installation. Do not press down
only in the middle of the module.
Memory module
45
To Next Page
Loading...
