c. Disconnect the display cable from the system board ZIF connector (3), and then remove the cable
from the routing channel in the left speaker (4).
d. Remove the four Torx T8 2.5 × 4.0 screws (1) that secure the display assembly to the computer.
e. Separate the display from the computer (2).
13. If it is necessary to remove the hinges from the display enclosure, remove the two Phillips broad head
M2.5 × 2.5 screws (1) and the Phillips M2.0 × 4.0 screw (2) from the bottom of each hinge.
Component replacement procedures 61
To Next Page
Loading...
