HP ProCurve 1810G-24 User Manual

2-8
Installing the Switch
Installation Procedure
3. Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws, then tighten these screws.
4. Install the other number 12-24 screw into the upper hole in each bracket.
Tighten these screws.
Lower switch with mounting
brackets onto the partially
installed screw
Install additional
screw

HP ProCurve 1810G-24 Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
VLAN Support	Yes
Throughput	35.7 Mpps
MAC Address Table Size	8000 entries
Jumbo Frame Support	Yes
Input Voltage	100-240 VAC
Forwarding Rate	35.7 Mpps
Management	Web-based management
Uplink Ports	2 x SFP
Operating Temperature	0°C to 40°C
Operating Humidity	15% to 95% non-condensing
Ports	24