EasyManuals Logo

HP ProCurve 2600-PWR Series User Manual

HP ProCurve 2600-PWR Series
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
--------------- -----
Web and MAC Authentication for the Series 2600/2600-PWR and 2800 Switches
Configuring the Switch To Access a RADIUS Server
Optional. Specifies an encryption key for use during
authentication (or accounting) sessions with the speci-
fied server. This key must match the encryption key used
on the RADIUS server. Use this command only if the
specified server requires a different encryption key than
configured for the global encryption key, above.
The no form of the command removes the key configured
for a specific server.
For example, to configure the switch to access a RADIUS server at IP address
192.168.32.11 using a server-specific shared secret key of ‘2Pzo22’
HPswitch(config)# radius-server host 192.168.32.11 key 2Pzo22
HPswitch(config)# show radius
S tatus and Counters - General RADIUS Information
Deadtime(min) : 0
Timeout(secs) : 5
Retransmit Attempts : 3
Global Encryption Key :
A uth Acc t
Server IP Addr Port Por t Encryption Key
--- -- --------------------------------
192.168.32.11 1812 181 3 2Pzo22
HPswitch(config)#
Figure 3-4. Example of Configuring a Switch To Access a RADIUS Server
3-16

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 2600-PWR Series and is the answer not in the manual?

HP ProCurve 2600-PWR Series Specifications

General IconGeneral
BrandHP
ModelProCurve 2600-PWR Series
CategorySwitch
LanguageEnglish

Related product manuals