Web and MAC Authentication for the Series 2600/2600-PWR and 2800 Switches
Show Status and Configuration of Web-Based Authentication
Specifies the VLAN to use for a client that fails authen-
tication. If unauth-vid is 0, no VLAN changes occur.
Use the no form of the command to set the unauth-vid to 0.
(Default: 0)
Show Status and Configuration of Web-
Based Authentication
Command Page
show port-access [
port-list] web-based 3-26
[clients] 3-26
[config] 3-26
[config [auth-server]] 3-27
[config [web-server]] 3-27
show port-access
port-list web-based config detail 3-27
Syntax: show port-access [port-list] web-based
Shows the status of all Web-Authentication enabled
ports or the specified ports. The number of authorized
and unauthorized clients is listed for each port, as well
as its current VLAN ID. Ports without Web Authenti-
cation enabled are not listed.
Syntax: show port-access [port-list] web-based [clients]]
Shows the port address, Web address, session status,
and elapsed session time for attached clients on all
ports or the specified ports. Ports with multiple clients
have an entry for each attached client. Ports without
any attached clients are not listed.
Syntax: show port-access [port-list] web-based [config]
3-26
To Next Page
Loading...
Need help?
General