HP ProCurve 2810 Series Access Security Guide

7-21
Configuring Secure Socket Layer (SSL)
Common Errors in SSL Setup
Common Errors in SSL Setup
Error During Possible Cause
Generating host certificate on CLI You have not generated a certificate
key. (Refer to “CLI commands used to
generate a Server Host Certificate” on
page 7-10.)
Enabling SSL on the CLI or Web browser interface You have not generated a host
certificate. (Refer to “Generate a Self-
Signed Host Certificate with the Web
browser interface” on page 7-13.)
You may be using a reserved TCP port.
(Refer to “Note on Port Number” on
page 7-20.)
Unable to Connect with SSL You may not have SSL enabled (Refer
to “3. Enable SSL on the Switch and
Anticipate SSL Browser Contact
Behavior” on page 7-17.)
Your browser may not support SSLv3
or TLSv1 or it may be disabled. (Refer
to the documentation provided for
your browser.)

HP ProCurve 2810 Series Specifications

General

Jumbo Frame Support	Yes
Model	HP ProCurve 2810 Series
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 SFP (mini-GBIC) slots
Forwarding Rate	71.4 Mpps
Layer	Layer 2
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static IP routing
Form Factor	Rack-mountable
Power Consumption	48W (24-port)
Operating Temperature	32°F to 0°F (0°C to 0°C)
Operating Humidity	15% to 95% non-condensing
Power Supply	Internal power supply