8-47
Configuring Port-Based and Client-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
Displaying 802.1X Configuration,
Statistics, and Counters
Show Commands for Port-Access Authenticator
802.1X Authentication Commands page 8-17
802.1X Supplicant Commands page 8-42
802.1X Open VLAN Mode Commands page 8-26
802.1X-Related Show Commands
show port-access authenticator below
show port-access supplicant page 8-53
Details of 802.1X Mode Status Listings page 8-49
RADIUS server configuration pages 8-24
Syntax: show port-access authenticator [[e] < port-list >]
[config | statistics | session-counters]
•Without [< port-list > [config | statistics | session-
counters]], displays whether port-access
authenticator is active (Yes or No) and the status of
all ports configured for 802.1X authentication. The
Authenticator Backend State in this data refers to the
switch’s interaction with the authentication server.
•With < port-list > only, same as above, but limits port
status to only the specified port. Does not display
data for a specified port that is not enabled as an
authenticator.
•With [< port-list > [config | statistics | session-counters]],
displays the [config | statistics | session-counters] data
for the specified port(s). Does not display data for a
specified port that is not enabled as an authenticator.
•With [config | statistics | session-counters] only,
displays the [config | statistics | session-counters] data
for all ports enabled as authenticators.
For descriptions of [config | statistics | session-counters]
refer to the next section of this table.
To Next Page
Loading...
Need help?
General
