HP ProCurve 2810 Series Access Security Guide

9-35
Configuring and Monitoring Port Security
Reading Intrusion Alerts and Resetting Alert Flags
Using the Event Log To Find Intrusion Alerts
The Event Log lists port security intrusions as:
W MM/DD/YY HH:MM:SS FFI: port A3 - Security Violation
where “
W” is the severity level of the log entry and FFI is the system module
that generated the entry. For further information, display the Intrusion Log,
as shown below.
From the CLI. Type the log command from the Manager or Configuration
level.
Syntax: log [search-text ]
For search-text , you can use ffi, security, or violation. For example:
Figure 9-19. Example of Log Listing With and Without Detected Security Violations
From the Menu Interface: In the Main Menu, click on 4. Event Log and use
N
ext page and Prev page to review the Event Log contents.
For More Event Log Information. See “Using the Event Log To Identify
Problem Sources” in the “Troubleshooting” chapter of the Management and
Configuration Guide for your switch.
Log Listing with
Security Violation
Detected
Log Listing with No
Security Violation
Detected
Log Command with “security”
for Search String

HP ProCurve 2810 Series Specifications

General

Jumbo Frame Support	Yes
Model	HP ProCurve 2810 Series
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 SFP (mini-GBIC) slots
Forwarding Rate	71.4 Mpps
Layer	Layer 2
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static IP routing
Form Factor	Rack-mountable
Power Consumption	48W (24-port)
Operating Temperature	32°F to 0°F (0°C to 0°C)
Operating Humidity	15% to 95% non-condensing
Power Supply	Internal power supply