4-9
TACACS+ Authentication
Configuring TACACS+ on the Switch
CLI Commands Described in this Section
Viewing the Switch’s Current Authentication
Configuration
This command lists the number of login attempts the switch allows in a single
login session, and the primary/secondary access methods configured for each
type of access.
Syntax:
show authentication
This example shows the default authentication configuration.
Figure 4-2. Example Listing of the Switch’s Authentication Configuration
Command Page
show authentication 4-9
show tacacs 4-10
aaa authentication pages 4-11 through 4-14
console
Telnet
num-attempts <1-10 >
tacacs-server pages 4-15
host < ip-addr > pages 4-15
key 4-19
timeout < 1-255 > 4-20
Configuration for login and enable access
to the switch through the switch console
port.
Configuration for login and enable access
to the switch through Telnet.
To Next Page
Loading...
