HP ProCurve 2810 Series Access Security Guide

8-25
Configuring Port-Based and Client-Based Access Control (802.1X)
Configuring Switch Ports as 802.1X Authenticators
6. Optionally Resetting Authenticator Operation
After authentication has begun operating, these commands can be used to
reset authentication and related statistics on specific ports.
Syntax: aaa port-access authenticator < port-list >
[initialize]
On the specified ports, blocks inbound and outbound
traffic and restarts the 802.1X authentication process.
This happens only on ports configured with control auto
and actively operating as 802.1X authenticators.
[reauthenticate]
On the specified ports, forces reauthentication (unless
the authenticator is in “HELD” state).
[clear-statistics]
On the specified ports, clears authenticator statistics
counters.

HP ProCurve 2810 Series Specifications

General

Jumbo Frame Support	Yes
Model	HP ProCurve 2810 Series
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 SFP (mini-GBIC) slots
Forwarding Rate	71.4 Mpps
Layer	Layer 2
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static IP routing
Form Factor	Rack-mountable
Power Consumption	48W (24-port)
Operating Temperature	32°F to 0°F (0°C to 0°C)
Operating Humidity	15% to 95% non-condensing
Power Supply	Internal power supply