9-37
Configuring and Monitoring Port Security
Operating Notes for Port Security
the alert flag status for the port referenced in the dropped entry. This means
that, even if an entry is forced off of the Intrusion Log, no new intrusions can
be logged on the port referenced in that entry until you reset the alert flags.
LACP Not Available on Ports Configured for Port Security. To main-
tain security, LACP is not allowed on ports configured for port security. If you
configure port security on a port on which LACP (active or passive) is
configured, the switch removes the LACP configuration, displays a notice that
LACP is disabled on the port(s), and enables port security on that port. For
example:
ProCurve(config)# port-security e a17 learn-mode static
address-limit 2
LACP has been disabled on secured port(s).
ProCurve(config)#
The switch will not allow you to configure LACP on a port on which port
security is enabled. For example:
ProCurve(config)# int e a17 lacp passive
Error configuring port A17: LACP and port security cannot
be run together.
ProCurve(config)#
To restore LACP to the port, you must remove port security and re-enable
LACP active or passive.
To Next Page
Loading...
Need help?
General