To Next Page

To Previous Page

3-16

Web and MAC Authentication

Configuring the Switch To Access a RADIUS Server

For example, to configure the switch to access a RADIUS server at IP address

192.168.32.11 using a server-specific shared secret key of ‘2Pzo22’

Figure 3-4. Example of Configuring a Switch To Access a RADIUS Server

Syntax: radius-server host < ip-address > key <server-specific key-string>

[no] radius-server host < ip-address > key

Optional. Specifies an encryption key for use during

authentication (or accounting) sessions with the speci-

fied server. This key must match the encryption key used

on the RADIUS server. Use this command only if the

specified server requires a different encryption key than

configured for the global encryption key, above.

The no form of the command removes the key configured

for a specific server.

ProCurve(config)# radius-server host 192.168.32.11 key

2Pzo22

ProCurve(config)# show radius

Status and Counters - General RADIUS Information

Deadtime(min) : 0

Timeout(secs) : 5

Retransmit Attempts : 3

Global Encryption Key :

Auth Acct

Server IP Addr Port Port Encryption Key

--------------- ----- ----- ------------------------------

192.168.32.11 1812 1813 2Pzo22

ProCurve(config)#

HP ProCurve 2810 Series Specifications

General

HP ProCurve 2810 Series Access Security Guide

Other manuals for HP ProCurve 2810 Series