HP ProCurve 3400cl-48G

1-10
Introducing the Switch
Back of the Switch
Introducing the Switch
Back of the Switch
Console Port
This port is used to connect a console to the switch by using the serial cable
supplied with the switch. This connection is described under “Connect a
Console to the Switch” in chapter 2, “Installing the Switch.” The console can
be a PC or workstation running a VT-100 terminal emulator, or a VT-100
terminal. The console port is located on the front of the 3400cl-24G and on the
back of the 3400cl-48G.
Power Connector
The Series 3400cl Switch devices do not have a power switch; they are
powered on when connected to an active AC power source. These switches
automatically adjust to any voltage between 100--127 and 200--240 volts and
either 50 or 60 Hz. There are no voltage range settings required.
AC power connector
Cooling vents - make sure this is not
obstructed for proper switch operation
ProCurve Switch 3400cl-24G
RPS Input Port
Optional cl module slot
ProCurve Switch 3400cl-48G
Cooling vents - make sure this is not
obstructed for proper switch operation
AC power connector
Console Port
RPS Input Port
Auxiliary Port and LED
Optional cl module slot