Key Management System
Configuring Key Chain Management
Note Given transmission delays and the variations in the time value from switch to
switch, it is advisable to include some flexibility in the Accept lifetime of the
keys you configure. Otherwise, the switch may disregard some packets
because either their key has expired while in transport or there are significant
time variations between switches.
To list the result of the commands in figure 11-3:
Figure 11-4. Display of Time-Dependent Keys in the Key Chain Entry
You can use show key-chain to display the key status at the time the command
is issued. Using the information from the example configuration in figures
11-3 and 11-4, if you execute show key-chain at 8:05 on 01/19/03, the display
would appear as follows:
Figure 11-5. Status of Keys in Key Chain Entry “Procurve2”
11-7
To Next Page
Loading...
Need help?
General