HP ProCurve Wireless Access Point 530 - Page 49

3-7
Getting Started With Access Point Configuration
Getting Started With Access
Point Configuration
5. To enable radio 1 for the access point, type exit to return to the configu-
ration mode for radio 1, then type enable to enable the radio.
6. To configure the access point’s radio 2 interface, type radio 2 and repeat
steps 1 to 4. Note that when the radio 2 interface mode is set to 802.11a,
the available channels are 36 to 165, depending on the country setting.
7. To save all configuration settings from the running configuration file to
the startup configuration file, type write memory from any command level.
ProCurve Access Point 530(radio1-wlan1)# exit
ProCurve Access Point 530(radio1)# enable
ProCurve Access Point 530(radio1)#
ProCurve Access Point 530(radio1-wlan1)# write memory
ProCurve Access Point 530(radio1-wlan1)#