EasyManuals Logo

HP ProDesk 405 G1 Microtower User Manual

HP ProDesk 405 G1 Microtower
165 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
4. Locate, press, and hold the CMOS button in for five seconds.
NOTE: Make sure you have disconnected the AC power cord from the wall outlet. The CMOS
button will not clear CMOS if the power cord is connected.
NOTE: For assistance locating the CMOS button and other system board components, see the
Illustrated Parts & Service Map (IPSM).
5. Replace the computer cover or access panel.
6. Reconnect the external devices.
7. Plug in the computer and turn on power.
NOTE: You will receive POST error messages after clearing CMOS and rebooting advising you
that configuration changes have occurred. Use Computer Setup to reset any special system setups
along with the date and time.
For instructions on Computer Setup, see Computer Setup (F10) Utility on page 64.
Clearing and resetting the CMOS
131

Table of Contents

Other manuals for HP ProDesk 405 G1 Microtower

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProDesk 405 G1 Microtower and is the answer not in the manual?

HP ProDesk 405 G1 Microtower Specifications

General IconGeneral
BrandHP
ModelProDesk 405 G1 Microtower
CategoryDesktop
LanguageEnglish

Related product manuals