Drives
Description Spare part number
Optical drives
DVD±RW drive 690418-001
DVD-ROM drive 682550-001
Blu-ray BD-RW SuperMulti XL Drive 682219-001
Hard drives
2 TB, 7200 rpm hard drive, 3.5 inch 747993-001
1 TB hard drive, hybrid SSD 724937-001
1 TB, 7200 rpm hard drive, 3.5 inch 747992-001
500 GB, 7200 rpm hard drive, 3.5 inch 747991-001
500 GB hard drive, hybrid SSD 724938-001
256 GB Solid State Drive (SSD), self-encrypting (SED) 680020-001
128 GB Solid State Drive (SSD) 665961-001
Card reader, 14-in-1, USB 3.0, 3.5-inch 716390-001
Adapter, USB 3.0 to 2.0 736835-001
When installing drives, follow these guidelines:
●
The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA
connector on the system board labeled SATA0.
●
Connect a secondary hard drive or an optical drive to the light blue SATA connector on the system
board labeled SATA1.
●
Connect a media card reader USB 3.0 cable to a USB 3.0 to USB 2.0 adapter and connect the
adapter to the black USB 2.0 connector on the system board labeled MEDIA.
●
The power cable for the drives has two branches coming out of the power supply. The first branch
is a two-headed cable routed to the two 5.25-inch bays. The second branch is a two-headed
cable routed to the two 3.5-inch hard drive bays.
●
HP has provided extra drive mounting screws (four silver 6-32 mounting screws and three black
M3 mounting screws) installed on the front of the chassis behind the bezel. The 6-32 mounting
screws are required for 3.5-inch hard drives installed in the 3.5-inch hard drive bays and for a
USB 3.0 media card reader installed in the 3.5-inch optional drive bay. M3 metric mounting
screws are required for 5.25-inch optical drives. If you are replacing a drive, remove the mounting
screws from the old drive and install them in the new drive.
Drives
39
To Next Page
Loading...
