Hardware options installation 43
• Each channel can have a different valid online spare configuration.
• Each populated channel must have a spare rank.
• A single dual-rank DIMM is not a valid configuration
After installing the DIMMs, use RBSU to configure the system for Online Spare memory support.
Installing a DIMM
1. If installed, remove the rack bezel (on page 59).
2. Power down the server (on page 17).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Extend the server from the rack (on page 17).
5. Remove the access panel (on page 19).
6. Remove the processor air baffle (on page 19).
7. Open the DIMM slot latches.
8. Install the DIMM.
9. Install the processor air baffle (on page 20).
10. Install the access panel (on page 19).
11. Slide the server into the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server (on page 17).
15. If removed, install the rack bezel (on page 60).
If you are installing DIMMs in online spare or lock-step configuration, configure this mode in RBSU ("HP
ROM-Based Setup Utility" on page 76).
To Next Page
Loading...
