Removal and Replacement Procedures 29
Figure 1 Removing the Top Cover
To reinstall the top cover:
1. Align the top cover to the chassis and then slide it towards the front panel to position it into
place.
2. Once the cover is attached to the chassis, tighten the captive screw on the rear panel with a T-10
screwdriver.
Figure 2 Reinstalling the Top Cover
Top Middle Cover
To remove the top middle cover:
1. Remove the top cover.
2. Remove the four screws (one on each side of the chassis and two on the top middle cover) that
secure the top middle cover to the chassis.
3. Lift the top middle cover away from the chassis.
To Next Page
Loading...
