HP PROLIANT DL180 - Memory

Removal and Replacement Procedures 49
To install the air baffle:
1. Align the air baffle hooks with the holes on the chassis.
2. Gently rotate the air baffle down.
Figure 29 Installing the air baffle
Memory
The HP ProLiant DL180 server has four DIMM slots that support up to 16 GB maximum system memory
(4 GB in each of the four DIMM slots).
You must adhere to the following guidelines when adding or replacing memory modules:
• For 2P system, both physical processors must be of the same type and speed.
• Use 533/677 MHz ECC FBD (Buffered DIMM).
• Supported DIMM: 512 MB, 1 GB, 2 GB and 4 GB (16 GB maximum capacity).
• Supported configurations: Single DIMM in slot 1, one identical pair in Slot 1&3, two pairs (4
DIMMs).