Removal and Replacement Procedures 45
Figure 24 Removing the Air Baffle
To remove the heat sink:
CAUTION: To prevent the heat sink from tilting to one side during installation and removal
procedures, use a diagonally opposite pattern (an “X” pattern) when loosening and tightening the
four spring-loaded screws. Do not over tighten the heat sink’s spring-loaded screws to prevent them
from breaking off. A maximum torque of 4 in-Ib is set for the system.
1. Loosen the four mounting pins.
2. Lift the heat sink away from the system board.
CAUTION: Place heat sink down in an upright position with the thermal patch facing upward. Do
not let the thermal patch touch the work surface.
Figure 25 Removing heat sink assembly
To Next Page
Loading...
