Removal and replacement procedures 34
2.
Remove the power supply blank.
To replace the component, reverse the removal procedure.
Hot-plug power supply
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 28).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Access the rear panel ("Access the product rear panel" on page 29).
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
4. Remove the power supply.
To Next Page
Loading...
