Removal and replacement procedures 54
Dedicated iLO management port option
To install the component:
1. Power down the server (on page 28).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 29).
o Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 35).
5. Using a flat screwdriver, toggle the knockout to loosen it, and then pull it out of the chassis.
To Next Page
Loading...
