Removal and replacement procedures 52
7.
Remove the capacitor pack.
To replace the component, reverse the removal procedure.
Capacitor pack holder
To remove the component:
1. Power down the server (on page 28).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack (on page 29).
b. Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 35).
5. Remove the capacitor pack ("Capacitor pack" on page 50).
To Next Page
Loading...
