Hardware options installation 67
6.
Install the TPM board. Press down on the connector to seat the board ("System board components" on
page 10).
7. Install the TPM security rivet by pressing the rivet firmly into the system board.
8. Install the PCI riser cage (on page 21).
9. Install the access panel (on page 20).
10. Install the server into the rack ("Installing the server into the rack" on page 27).
11. Power up the server (on page 17).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
To Next Page
Loading...
