Hardware options installation 55
The second (left) capacitor pack cable connects to an optional Smart Array expansion board.
8. Install the PCI riser cage (on page 25).
9. Install the access panel (on page 23).
10. Slide the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (on page 20).
Front video adapter option
Depending on the model purchased, the server may look different than shown.
The 10 SFF drive configuration does not support the front video adapter.
To install the component:
1. Connect the front video adapter to the front video connector.
CAUTION: Be sure to connect the video adapter to the video connector, and not to the USB
connector.
To Next Page
Loading...
