EasyManuals Logo

HP ProLiant DL380p User Manual

HP ProLiant DL380p
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
Operations 30
7.
Secure the full-length expansion board retainer.
8. Install the access panel (on page 23).
9. Install the server into the rack ("Installing the server into the rack" on page 36).
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server (on page 21).
Remove the air baffle
CAUTION: For proper cooling do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
1. Power down the server (on page 21).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend or remove the server from the rack ("Extend the server from the rack" on page 21).
4. Remove the access panel (on page 22).
CAUTION: Do not detach the cable that connects the battery pack to the cache module.
Detaching the cable causes any unsaved data in the cache module to be lost.
IMPORTANT: It is necessary to remove the PCI riser cage only if there is a full-length expansion
board installed.

Table of Contents

Other manuals for HP ProLiant DL380p

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProLiant DL380p and is the answer not in the manual?

HP ProLiant DL380p Specifications

General IconGeneral
ProcessorIntel Xeon E5-2600 series
Processor Sockets2
MemoryUp to 768GB DDR3
Memory Slots24 DIMM slots
Expansion SlotsUp to 6 PCIe 3.0 slots
Form Factor2U rack
StorageUp to 25 SFF or 12 LFF drive bays
RAID SupportSmart Array P420i controller, supports RAID 0, 1, 5, 6, 10, 50, 60
Network4x 1GbE embedded ports
Power SupplyUp to 2x 460W, 750W, or 1200W PSUs
Operating System SupportWindows Server, RHEL, SUSE, VMware

Related product manuals