Removal and replacement procedures 57
To remove the component:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 27).
o Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 35).
5. Remove the air baffle ("Air baffle" on page 36).
6. Remove the onboard PCIe3 x16 slot 1 cover.
7. Remove the primary PCI riser cage blank.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
