To Next Page

To Previous Page

System battery replacement 55

System battery replacement

If the server no longer automatically displays the correct date and time, you might have to replace the battery

that provides power to the real-time clock.

WARNING: The computer contains an internal lithium manganese dioxide, a vanadium

pentoxide, or an alkaline battery pack. A risk of fire and burns exists if the battery pack is not

properly handled. To reduce the risk of personal injury:

• Do not attempt to recharge the battery.

• Do not expose the battery to temperatures higher than 60°C (140°F).

• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.

• Replace only with the spare designated for this product.

1. Press the Power On/Standby button.

The server powers down and enters standby mode. The system power LED changes from green to

amber. Power is still applied to the server.

2. Disconnect the power cord from the power source.

3. Disconnect the power cord from the server.

4. Place the server on its side.

5. Remove the access panel (on page 12).

6. Locate the battery on the system board ("System board components" on page 8).

Other manuals for HP ProLiant ML10

Questions and Answers:

Need help?

Do you have a question about the HP ProLiant ML10 and is the answer not in the manual?

General

Memory Slots	4
Form Factor	Tower
Processor	Intel Xeon E3-1200 v3
Memory	Up to 32 GB
Drive Bays	4 LFF
Power Supply	300W
Chipset	Intel C222
Expansion Slots	1 PCIe 3.0 x16, 1 PCIe 2.0 x1
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
RAID Support	Integrated SATA RAID controller (Intel Rapid Storage Controller); optional HP Smart Array controllers