Hardware options installation 63
To install a half-height or full-height media device:
1. Power down the server (on page 24).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 25).
o Extend the server from the rack (on page 24).
3. Remove the access panel (on page 26).
4. Remove the media bay blank (on page 27).
5. Install the guide screws ("Identifying guide screws" on page 62), if applicable.
6. Slide the drive about three-fourths of the way into the bay, leaving room to connect cables at the back
of the drive.
o Half-height device
o Full-height device
7. Connect the data and power cables to the rear of the device.
To Next Page
Loading...
