Hardware options installation 86
5. Install the TPM board. Press down on the connector to seat the board ("System board components" on
page 11).
6. Install the TPM security rivet by pressing the rivet firmly into the system board.
7. Install the access panel (on page 27).
8. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
9. Power up the server (on page 24).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To Next Page
Loading...
