HP StorageWorks 4/8 - SAN Switch User Manual

Fabric OS 6.2 administrator guide 359
4. Log in to the backbone fabric and set up the TI zone.
a. Enter the following commands to create and display a TI zone:
BB_DCX_1:admin> zone --create -t ti TI_Zone1 -p "1,9; 1,1; 2,4; 2,7;
10:00:00:00:00:08:00:00; 10:00:00:00:00:02:00:00;
10:00:00:00:00:03:00:00"
BB_DCX_1:admin> zone --show
Defined TI zone configuration:
TI Zone Name: TI_Zone1
Port List: 1,9; 1,1; 2,4; 2,7; 10:00:00:00:00:08:00:00;
10:00:00:00:00:02:00:00; 10:00:00:00:00:03:00:00
Status: Activated Failover: Enabled
b. Enter the following commands to reactivate your current effective configuration and enforce the TI
zones.
BB_DCX_1:admin> cfgactvshow
Effective configuration:
cfg: cfg_TI
zone: lsan_t_i_TI_Zone1
10:00:00:00:00:00:02:00:00
10:00:00:00:00:00:03:00:00
10:00:00:00:00:00:08:00:00
BB_DCX_1:admin> cfgenable cfg_TI
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
If the update includes changes to one or more traffic isolation zones, the
update may result in localized disruption to traffic on ports associated
with the traffic isolation zone changes
Do you want to enable 'cfg_TI' configuration (yes, y, no, n): [no] y
zone config "cfg_TI" is in effect
Updating flash ...
QoS: Ingress Rate Limiting
Ingress rate limiting is a licensed feature that requires the Adaptive Networking license. Ingress rate
limiting restricts the speed of traffic from a particular device to the switch port. Use ingress rate limiting for
the following situations:
• To reduce existing congestion in the network or proactively avoid congestion.
• To enable you to offer flexible bandwidth limit services based on requirements.
• To enable more important devices to use the network bandwidth during specific services, such as
network backup.
To limit the traffic, set the maximum speed at which the traffic can flow through a particular F_Port or
FL_Port. For example, if you set the rate limit at 4 Gb/s, traffic from a particular device is limited to a
maximum of 4 Gb/s.
Ingress rate limiting enforcement is needed only if the port can run at a speed higher than the rate limit. For
example, if the rate limit is 4 Gb/s and the port is only a 2 Gb/s port, ingress rate limiting is not enforced.
The ingress rate limiting configuration is persistent across reboots.

HP StorageWorks 4/8 - SAN Switch Specifications

General

Brand	HP
Model	StorageWorks 4/8 - SAN Switch
Category	Switch
Language	English