To Next PageTo Next PageWhat to do for configuration file system error blink pattern on HP StorageWorks 8/20q?
If your HP Switch displays a configuration file system error blink pattern, you should restore the switch configuration by establishing communications with the switch using Telnet and entering the appropriate commands.
Why is E_Port isolation happening on my HP Switch?
E_Port isolation in an HP Switch can occur due to several reasons: * Security failure: Review the ISL group in the active security set to ensure that the membership includes the necessary ports and that the secrets on all switches are correct. * Incorrect port configuration: If a port configured as an F_Port or an FL_Port is connected to another switch, correct the port connection or the port type. * Conflicting domain IDs or timeout values: Correct these on the offending switches using the set config switch CLI command. * Conflicting zone membership: Deactivate one of the active zonesets or edit the conflicting zones so that their membership is the same, then reset the port. * Connection to a B-series or C-series switch: Contact your authorized maintenance provider.
General| Product Type | Fibre Channel Switch |
|---|---|
| Form Factor | Rack-mountable |
| Ports | 20 |
| Port Speed | 8 Gbps |
| Aggregate Switch Bandwidth | 320 Gbps |
| Fabric Type | Switched Fabric |
| Cooling | Fan |
| Fibre Channel Standards | FC-PH, FC-AL-2, FC-FLA, FC-GS-3 |
| Management Interface | Command Line Interface (CLI) |
| Hot-swappable Components | Power supplies, fans |
| Data Transfer Rate | 8 Gbps per port |
| Power Supply | AC 100-240 V (50/60 Hz) |
