Harmonics conformance (Japan)
German noise declaration
XP24000/XP20000: Schalldruckpegel Lp = 70 dB(A)
Am Arbeitsplatz (operator position)
Normaler Betrieb (normal operation)
Nach ISO 7779:1988 / EN 27779:1991 (Typprüfung)
Laser safety
When equipped with native Fibre Channel adapters, this product contains a laser internal to the
Optical Link Module (OLM) contained on the Channel Adapter boards for connection to a fibre
communications network.
In the USA, the OLM is certified as a Class 1 laser product conforming to the PRT requirements
contained in the Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter
J. The certification is indicated by a label on the plastic OLM housing. Outside the USA, the OLM is
certified as a Class 1 laser product conforming to the requirements contained in IEC 825-1:1993
and EN 60825-1:1994, including Amendment 11:1996.
The following figure shows the Class 1 information label that appears on the plastic housing of the
OLM.
CLASS 1 LASER PRODUCT
Complies with
21 CFR 1040.10 and 1040.11
Each communications port consists of a transmitter and receiver optical subassembly. The transmitter
subassembly contains an internal semiconductor laser diode in the wavelength range of 770 to 850
nanometers. In the event of a break anywhere in the fibre path, the OLM control system prevents laser
emissions from exceeding Class 1 levels. Class 1 laser products are not considered hazardous.
WARNING!
There are no user maintenance operations, service operations, or adjustments to be performed on
the Optical Link Module.
Japan DENAN law cordset caution
Please use the supplied power cord. The power cord may not be used with other products.
XP24000/XP20000 Disk Array Owner's Guide 51
To Next Page
Need help?
General