Figure 1: DIMM locations
Table 9: DIMM slot locations
Model Processor Slots
HPE StoreOnce 4900 Backup 1 1,2,4,5,8,9,11,12
2 1,2,4,5,8,9,11,12
The locations of DIMM slots are also shown on the StoreOnce hood label inside the server.
Identifying the Activation Key for the iLO4 license
All products are shipped with paper copies of the iLO4 licenses. If you no longer have these licenses and
the board is still working for the iLO4 GUI connection via its management Ethernet port, make a note of
the license before you remove the motherboard. (If it is not working, contact HPE Support.)
Procedure
1. Log on to the iLO4 GUI.
2. Select the Administration Tab.
3. Select Licensing and make a note of the Activation Key.
iLO and BIOS configuration after replacing the
motherboard
Configure the RBSU (ROM-Based Setup Utility) settings BEFORE connecting the FC, network, and SAS
cables to the server and BEFORE the system boots into the StoreOnce software, that is, during the
server POST sequence.
Identifying the Activation Key for the iLO4 license 27
To Next Page
Loading...
