5.
Remove the display hinge cover (2).
NOTE: The display hinge cover is included in the Plastics Kit, spare part number 592971-001.
6. Position the computer with the front toward you.
7. Release the tape (1) that secures the WLAN antenna cables to the system board.
8. Release the grounding tape (2) that grounds the WLAN antenna cables to the base enclosure.
9. Release the WLAN antenna cables (3) from the opening in the system board.
10. Release the grounding tape (1) that grounds the webcamera cable to the base enclosure.
56 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
