2. Attach a SAS-to-SATA cable adapter to the connector on the hard drive.
Figure 4-44 Attaching the adapter
3. Push the drive (1) into the selected bay until it snaps into place.
4. Attach the data (2) and power (3) cables to the drive.
Figure 4-45 Installing the SAS hard drive
5. Insert the SAS controller card into an available PCI slot.
6. Connect the data cable from the hard drive (1) to the controller card (2).
90 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
