4. Connect the power, drive, and audio (if required) cables to the drive and system board. On Linux
systems, connect the audio cable to the AUX-IN connector.
NOTE: The audio cable is only required for Linux-based systems.
Figure 4-35 Installing the optical drive
Optical drive (Desktop position)
To remove an optical drive:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Side access panel on page 62) and remove the front bezel (Front Bezel
on page 63).
2. Disconnect the data (1), power (2), and audio (3) cables from the drive. The connector colors might
be different than illustrated.
NOTE: The audio cable is only required for Linux-based systems.
Figure 4-36 Disconnecting the cables from the optical drive
ENWW Steps for removal and replacement of components 85
To Next Page
Loading...
