3. Remove the four screws (1) from the back panel.
4. Slide the power supply toward the front and lift it (2) out of the chassis.
Figure 4-15 Removing the power supply
To replace the power supply, reverse the previous steps.
System fan assembly
To remove the system fan assembly:
1. Disconnect power from the system (
Predisassembly procedures on page 57) and remove the side
access panel (
Side access panel on page 62).
2. Disconnect the fan plug (1) from the system board. .
ENWW Steps for removal and replacement of components 69
To Next Page
Loading...
