4. Connect the power, drive, and audio (if required) cables to the drive and system board. On Linux
systems, connect the audio cable to the AUX-IN connector.
NOTE: The audio cable is only required for Linux-based systems.
Figure 4-39 Connecting the optical drive cable to the system board
Diskette drive (optional)
To remove a diskette drive:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Side access panel on page 62), and the front bezel (Front Bezel on page 63).
2. Disconnect the data (1) and power (2) cables from the back of the diskette drive.
Figure 4-40 Disconnecting the cables from the diskette drive
ENWW Steps for removal and replacement of components 87
To Next Page
Loading...
