Slot Type Slot power (Maximum)
3 PCI Express x16 (4) 25 W
4 PCI Express x 1 25 W
5 PCI 32/33 25 W
6 PCI 32/33 25 W
* In addition to these slot power specifications, the overall power consumption of the system
(including I/O cards, processor, and memory) must not exceed the maximum ratings of the
system power supply.
PCI retainer
For added protection, some cards have PCI retainers installed to prevent movement during shipping.
To remove the PCI retainer:
1. Disconnect power from the system (
Predisassembly procedures on page 57) and remove the side
access panel (
Side access panel on page 62).
2. Remove the two screws (1) retaining the retainer and lift it (2) out of the chassis.
Figure 4-21 Removing the PCI retainer
To install the PCI retainer:
1. Disconnect power from the system (
Predisassembly procedures on page 57) and remove the side
access panel (
Side access panel on page 62).
2. Engage the rear bracket (1) with the holes in the rear of the chassis before rotating it down (2) into
position. .
Table 4-4 PCI slots (continued)
74 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
