4. After pulling the drive (1) out, remove the four guide screws (2) from the drive. Only remove the
four guide screws if you plan to install another drive.
Figure 4-34 Removing the optical drive screws
To install an optical drive:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Side access panel on page 62) and remove the front bezel (Front Bezel
on page 63).
2. Insert the four guide screws (1) into the drive.
3. Align the screws with the grooves in the drive bay and gently slide 2 the drive into the unit until it
snaps into place.
CAUTION: Ensure that the optical drive is secure by pulling to see if the drive can become easily
disengaged. Failure to do so can cause damage to the drive when moving the workstation.
84 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
