3. Lift up on the green drive-lock release tab (1) and slide the hard drive (2) out of the chassis.
Figure 4-48 Removing the hard drive
To install one or two SATA hard drives:
1. Disconnect power from the system (
Predisassembly procedures on page 57) and remove the side
access panel (
Side access panel on page 62).
2. Select a drive bay in which to install the drive.
3. Push the drive into the selected bay until it snaps into place.
4. Attach the data (1) and power (2) cables to the drive.
Figure 4-49 Installing the SATA hard drive
92 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
