2. Place the hard drive in the bracket (1) and secure with American National screws (2) as shown in
the following illustration.
Figure 4-51 Installing hard drive into bracket
3. Screw four screws to the bracket (1). Align the screws with the grooves in the optical drive bay and
slide the drive in (2) the chassis.
Figure 4-52 Installing hard drive into optical drive bay
4. Connect the data cable to the hard drive (1) and to the system board (2). SATA installation is shown.
94 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
