4. Attach a data cable from a SATA connector on the system board to the hard drive, and attach the
fifth drive power cable to the drive.
Figure 4-61 Attaching the data cable for the SATA hard drive in the fifth hard drive bay
5. For a SAS hard drive, attach a SAS/SATA adapter to the connector on the hard drive. Attach a
data cable from a SAS connector on the system board to the hard drive, and attach a power cable
to the drive.
Processor heatsink
Removing the CPU heatsink
NOTE: The following illustrated CPU heatsink is typical of what you might have in your workstation.
Be aware that different variations of the CPU heatsinks exist, but the overall procedures listed are
sufficient to assist you in removing the CPU heatsink.
1. Shut down the workstation, and disconnect power from the system ( Pre-disassembly
procedures on page 50). Remove the access panel (Access panel on page 57), and place the
workstation on its side with the system board facing up.
ENWW Removing and replacing components 93
To Next Page
Loading...
